新入荷再入荷

Amazon.co.jp: Panasonic WTA53839H Toilet Ventilation Switch,Bathroom Exhaust Fans | Panasonic North America - United States,Amazon.co.jp: Panasonic WTA53839W Advanced Series Embedded,Panasonic WhisperCeiling DC fan with LED lights, Pick-A-Flow,Panasonic WhisperChoice AutoPick-A-Flow 80/110 CFM Ceiling

• Size (W x D x H): 1.9 x 1.6 x 4.3 inches (48.1 x 41.1 x 110 mm); Color: Matte Gray; Material: Handle: Polycarbonate, ABS resin; Mounting frame: Zinc steel; Cover: PBT resin; Body: Urea
• Contact Method: Silver alloy-silver alloy; Butt contact/wiring method: Screwless terminal type (wire plug type)
• Circuit Method: Single-cut (0-1 terminal), Semiconductor (between 0-2 terminals), Bi-directional thyristor Rating: Lighting: 2A 100V AC, Ventilation Fan: 1A 100V AC, Rated Frequency: 50/60Hz
• Compliance Regulations: Electrical Appliances Safety Law (Specified Electrical Appliances); Reference Standards: JIS C 8304 (Small Switches for Indoor Use)
• Compatible Wires: Wire: 600V Vinyl Insulated Wire (IV), 600V Vinyl Insulated Vinyl Sheath Cable (VVF), 600V Flame Resistant Polyethylene Insulated Wire, 600V Polyethylene Cable: Diameter 0.06, 0.08 inch (1.6, 2 mm) Cu, Single Wire, Plate: WTA7101HK Advance Series Switch Plate, For Single Line Use, Matte Gray, etc. Ambient Temp: -1 0-40 degrees

Advanced Series Embedded Electronic Toilet Ventilation Switch.
The ventilation fan will be delayed after the light is turned off.

Note:
Not for use with HID loaded, special function lighting fixtures (dimmable and sensor functions).

Do not use on outlet circuits. If used incorrectly, the electrical outlet will be connected to a load other than the fan and cause a fire or unexpected accident.
Do not use over load capacity. It may cause heat to generate and cause burns or fires.
Do not use bent, scratched or tarnished wires. It may generate heat and cause fire.
When wiring, insert the wire into the terminal. If insufficient insertion is not enough, it may generate heat and may cause burns or fire.

Do not use with ventilation fans only. Because of the light interlock, it will not work properly.
Do not short-circuit the load side. Internal circuits are destroyed and cannot be used again.
Take off this product for line insulation resistance measures. You can leave the wires (trains) and ground spaces.
To facilitate wire storage, please ensure the depth of the mounting part. (9.5mm thick gypsum board + standard box estimated)
For construction without a box, please use scissor fittings WN3993K020, WN39929020, WN3990K (*only use with wide 21), push hardware WN3996020, etc.
Please install the wall thickness of 7mm or greater.
Use WVA7200W exposure box
Please clean the four corners of the wall holes to avoid the drop of the mounting frame.
The box screws should be tightened so that the mounting frame is not deformed.